Micro:bit with Servo Motor


The above image shows a Micro:bit hardwired into a servo motor which is just about its limit.

Block Editor Coding:

Servo Connection example:


Connecting The BBC micro:bit To The Servo:

The servo has a three wire connector. The brown wire is ground, the red wire is positive and the orange wire is the signal wire. The BBC micro:bit will send instructions to the servo from the P0 pin via the servo's signal wire.
Push the BBC micro:bit into the Breakout Board or use alligator clips.
Use the 3 x Jumper wires and 3 alligator clips to connect the Servo to the micro:bit, the table below shows how the connections are made.

BBC micro:bit  to Mini Servo

 3V Pin.   connects to Red servo wire

 GND.  connects to Brown servo wire

 P0 Pin. connects to Orange servo wire

Comments

Post a Comment

Popular posts from this blog

Micro:bit motor hardwired without motor board

Image
The output pins on the micro:bit can only supply a small amount of current, not enough current for a power demanding device such as a motor. A transistor can be used to solve this difficulty. A transistor is like a fence gate for electricity, a small amount of current can be used to open the fence gate to allow a lot of current to flow through to power demanding components. This is an example of building a micro:bit motor circuit with crocodile leads to join the components together. Transistor When connecting the transistor it is important to correctly identify the Base, Collector and Emitter leads. See image. Care needs to be taken when connecting the transistor to make sure there are no shorts. It is recommended you bend the pins away from each other before you connect the crocodile leads. Resistor: red, red,red, gold Microsoft has changed their URL for creating code. Go to: https://makecode.microbit.org/ and enter the following lines of code. Modify to your r
Read more

Micro:bits Radio Temperature Sensor Display Python Coding

Image
The above image shows 5 degrees C being displayed after the Sensor micro:bit was placed in a freezer. The following Python code was written in the Mu editor. You compile the coding to two separate micro:bits that have power. Place the sensor into a freezer or on an ice pack and watch the temperature change making use of radio waves for communication. This coding needs to be compiled onto the sensor micro:bit: ============================================= # Language: Python     Transcribed by: Steve Madsen # The microbit can make use of radio waves # This coding needs to be compiled to one of # two microbits. Both need their own power supply from microbit import * # import the radio module import radio # turn the radio on radio.on() while True:   # the temperature of the microbit   # is stored in a variable called temp   temp = temperature()   # send to the second microbit a   # string of the the variable temp where it   # will display
Read more